D-Link DGS-1100-06/ME - Enable Snmp System_Device_Bootup Traps; Disable Snmp System_Device_Bootup Traps

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
61
Success!
DGS-1100-06/ME:5#
enable snmp system_device_bootup traps
Purpose
To enable SNMP system device bootup traps support on the Switch.
Syntax
enable snmp system_device_bootup traps
Description
The enable snmp system_device_bootup traps command
enables SNMP system device bootup traps support on the Switch.
After enables the SNMP system device bootup traps support, the
Switch will send out a trap to the SNMP manage host when the
device is power on.
Parameters
None.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To enable the SNMP system device bootup traps on the Switch:
DGS-1100-06/ME:5#enable snmp system_device_bootup traps
Command: enable snmp system_device_bootup traps
Success!
DGS-1100-06/ME:5#
disable snmp system_device_bootup traps
Purpose
To disable SNMP system device bootup traps support on the Switch.
Syntax
disable snmp system_device_bootup traps
Description
The disable snmp system_device_bootup traps command
disables SNMP system device bootup traps support on the Switch.
Parameters
None.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To disable the SNMP system device bootup traps on the Switch:
DGS-1100-06/ME:5#disable snmp system_device_bootup traps
Command: disable snmp system_device_bootup traps
Success!
DGS-1100-06/ME:5#