D-Link DGS-1100-06/ME - Show Snmp V6 Host; Enable Snmp Traps

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
54
Command: delete snmp host 10.90.90.22
Success!
DGS-1100-06/ME:5#
show snmp v6host
Purpose
To display the recipient of SNMP traps generated by the Switch’s
SNMP agent.
Syntax
show snmp v6host {<ip6_addr>}
Description
The show snmp host command is used to display the IPv6
addresses and configuration information of remote SNMP managers
that are designated as recipients of SNMP traps generated by the
Switch’s SNMP agent.
Parameters
<ip6_addr> − The IPv6 address of a remote SNMP manager that
receives SNMP traps generated by the Switch’s SNMP agent.
Restrictions
None.
Example usage:
To display the currently configured SNMP hosts on the Switch:
DGS-1100-06/ME:5#show snmp v6host
Command: show snmp v6host
SNMP Host Table
(Maximum Entries : 10)
Host IP Address SNMP Version Community or User Name
------------------------------------ -------------------- -------------------------------------
3000::1 V3-NoAuthNoPriv dlink
Success!
DGS-1100-06/ME:5#
enable snmp traps
Purpose
To enable SNMP trap support.
Syntax
enable snmp traps
Description
The enable snmp traps command enables SNMP trap support on
the Switch.
Parameters
None.
Restrictions
Only Administrator or operator-level users can issue this command
Example usage:
To enable SNMP trap support on the Switch:
DGS-1100-06/ME:5#enable snmp traps