D-Link DGS-1100-06/ME - Delete Ports; Show Ports

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
31
 auto − Enables auto-negotiation for the specified range of
ports.
 [10 | 100 | 1000] − Configures the speed in Mbps for the
specified range of ports.
 [half | full] − Configures the specified range of ports as either
full or half-duplex.
Restrictions
Only administrator or operate-level users can issue this command.
Example usage:
To configure the speed of ports 1-3 to be 100 Mbps, full duplex, learning and state enabled:
DGS-1100-06/ME:5#config ports 1-3 medium_type copper speed 100_full learning
enable state enable
Command: config ports 1-3 medium_type copper speed 100_full learning enable
state enable
Success
DGS-1100-06/ME:5#
delete ports
Purpose
To delete the description of current configuration port.
Syntax
delete ports [<portlist> | all] medium_type [copper | fiber_100 |
fiber_1G] description
Description
The delete ports command deletes the description of current
configuration port or range of ports.
Parameters
[<portlist> | all] − All port or range of ports whose settings are to be
removed.
medium_type [copper | fiber_100 | fiber_1G] − If configuring the
Combo ports, this description the type of medium being removed.
Restrictions
Only administrator or operate-level users can issue this command.
Example usage:
To delete the description of port 3 on the Switch:
DGS-1100-06/ME:5# delete ports 3 medium_type copper description
Command: delete ports 3 medium_type copper description
DGS-1100-06/ME:5#
show ports
Purpose
To display the current configuration of a range of ports.
Syntax
show ports {<portlist> | all} {description | err_disabled}
Description
The show ports command displays the current configuration of a
port or range of ports.
Parameters
<portlist> − A port or range of ports whose settings are to be
displayed.
all – Specifies all ports to be displayed.