D-Link DGS-1100-06/ME - Config Igmp_Snooping Querier_Selection; Config Igmp_Snooping Robustness_Variable

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
144
The range is from 60 to 600 seconds.
Restrictions
Only administrator or operator-level users can issue this command.
Example usage:
To configure the igmp snooping:
DGS-1100-06/ME:5# config igmp_snooping querier vlanid 2 state enable
last_member_query_interval 2
Command: config igmp_snooping querier vlanid 2 state enable
last_member_query_interval 2
Success !
DGS-1100-06/ME:5#
config igmp_snooping querier_selection
Purpose
To configure IGMP snooping querier selection on the Switch.
Syntax
config igmp_snooping querier_selection [vlan_name <string
20> | vlanid <vidlist> | all] state [enable | disable]
Description
The config igmp_snooping querier_selection command
configures IGMP snooping querier selection on a specific VLAN.
Parameters
vlan_name <string 20> − The name of the VLAN for which IGMP
snooping is to be configured. Up to 20 characters can be used.
vlanid <vidlist> − The VLAN id for which IGMP snooping is to be
configured.
all − Specifies all VLAN for which IGMP snooping is to be
configured.
state [enable | disable] − Enables/Disables IGMP Snooping Querier.
Restrictions
Only administrator or operator-level users can issue this command.
Example usage:
To configure the igmp snooping querier selection:
DGS-1100-06/ME:5#config igmp_snooping querier_selection vlanid 2
disable
Command: config igmp_snooping querier_selection vlanid 2 disable
Success !
DGS-1100-06/ME:5#
config igmp_snooping robustness_variable
Purpose
To configure IGMP snooping robustness variable on the Switch.
Syntax
config igmp_snooping robustness_variable <integer 2-255>
Description
The config igmp_snooping robustness variable command
configures IGMP snooping robustness variable on the Switch.
Parameters
<integer 2-255> − The IGMP snooping robustness variable of IGMP
snooping is to be configured.