D-Link DGS-1100-06/ME - Config Ethernet_Oam Ports (Link Monitor Error Frame)

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
251
To configure the error symbol threshold to 2 and period to 1000ms for port 1:
DGS-1100-06/ME:5# config ethernet_oam ports 1 link_monitor error_symbol
threshold 2 window 1000 notify_state enable
Command: config ethernet_oam ports 1 link_monitor error_symbol threshold 2
window 1000 notify_state enable
Success!
DGS-1100-06/ME:5#
config ethernet_oam ports (link monitor error frame)
Purpose
Used to configure Ethernet OAM link monitoring error frame
configuration for ports.
Syntax
config ethernet_oam ports [all | <portlist>] link_monitor
error_frame {threshold <integer 1-4294967295> | window <
integer 1000-60000> | notify_state [enable | disable]}
Description
The config ethernet_oam ports command is used to configure
Ethernet OAM link monitoring error frames for ports.
Link monitoring function provides a mechanism to detect and
indicate link faults under a variety of conditions. OAM monitors the
counts of the number of frame errors as well as the number of
coding symbol errors. When the number of frame errors is equal to
or greater than the specified threshold in a period and the event
notification state is enabled, it generates an error frame event to
notify the remote OAM peer.
Parameters
[all | <portlist>] – Specifies a range of ports or all ports to be
configured.
threshold <integer 1-4294967295> – Specify the number of frame
errors in the period that must be equal to or greater than in order for
the event to be generated. The default value is 1 frame error.
window <integer 1000-60000> –The range is 1000 to 60000 ms. The
default value is 1000ms.
notify_state [enable | disable] – Specify to enable or disable event
notification. The default state is enabled.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To configure the error symbol threshold to 2 and period to 1000ms for port 1:
DGS-1100-06/ME:5# config ethernet_oam ports 1 link_monitor error_frame
threshold 2 window 1000 notify_state enable
Command: config ethernet_oam ports 1 link_monitor error_frame threshold 2
window 1000 notify_state enable
Success!
DGS-1100-06/ME:5#