D-Link DGS-1100-06/ME - Logout; Ping

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
21
DGS-1100-06/ME:5# reset system
Command: reset system
Are you sure you want to proceed with the system reset, save and
reboot?(y/n)y
% Success.
DGS-1100-06/ME:5# System will Reboot....
Boot Procedure
-------------------------------------------------------------------------------
PP_init for CAMEO DGS-1100-06ME(instead of EEPROM)
Please wait, loading Runtime image ........................ 100%
MAC Address : 00-AE-B7-21-22-62
H/W Version : Rev.A1
F/W Version : 1.00.008
...........................................
DGS-1100-06/ME Gigabit Ethernet Switch
Command Line Interface
Copyright(C) 2012 D-Link Corporation. All rights reserved.
DGS-1100-06/ME login:
logout
Purpose
To log out a user from the Switch.
Syntax
Logout
Description
The logout command terminates the current user’s session on the
Switch.
Parameters
None.
Restrictions
None.
Example usage:
To terminate the current user’s Telnet session:
DGS-1100-06/ME:5# logout
ping
Purpose
To test the connectivity between network devices.
Syntax
ping <ipaddr> {times <value 1-255> | timeout <sec 1-99> | size
<short 0-2080>}
Description
The ping command sends Internet Control Message Protocol
(ICMP) echo messages to a remote IP address. The remote IP