D-Link DGS-1100-06/ME - Config Radius Add; Config Radius Delete

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
180
DGS-1100-06/ME:5#config 802.1x reauth port_based ports 1-2
Command: config 802.1x reauth port_based ports 1-2
Success.
DGS-1100-06/ME:5#
config radius add
Purpose
To configure the settings the Switch uses to communicate with a
RADIUS server.
Syntax
config radius add <server_index 1-3> [<ipaddr> | <ipv6_addr>]
[key <passwd 32>] {default | auth_port <udp_port_number 1-
65535> | acct_port <udp_port_number 1-65535>}
Description
The config radius add command configures the settings the Switch
uses to communicate with a RADIUS server.
Parameters
<server_index 1-3> – The index of the RADIUS server.
[<ipaddr> | <ipv6_addr]> – The IPv4 or IPv6 address of the RADIUS
server.
key – Specifies that a password and encryption key are to be used
between the Switch and the RADIUS server.
<passwd 32> – The shared-secret key used by the RADIUS server
and the Switch. Up to 128 characters can be used.
default – Uses the default udp port number in both the auth_port and
acct_port settings.
auth_port <udp_port_number 1-65535> – The UDP port number for
authentication requests. The default is 1812.
acct_port <udp_port_number 1-65535> – The UDP port number for
accounting requests. The default is 1813.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To configure the RADIUS server communication settings:
DGS-1100-06/ME:5#config radius add 1 10.48.47.11 key dlink default
Command: config radius add 1 10.48.47.11 key dlink default
Success!
DGS-1100-06/ME:5#
config radius delete
Purpose
To delete a previously entered RADIUS server configuration.
Syntax
config radius delete <server_index 1-3>
Description
The config radius delete command deletes a previously entered
RADIUS server configuration.
Parameters
<server_index 1-3> – The index of the RADIUS server.
Restrictions
Only Administrator or operator-level users can issue this command.