DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
133
when the Q-in-Q mode is disabled.
<portlist> - A range of ports to configure.
all – Specifies all ports to be configure.
role - Port role in Q-in-Q mode, it can be UNI port or NNI port.
outer_tpid - TPID in the SP-VLAN tag.
Only administrator-level users can issue this command.
Example usage:
To configure all ports as UNI port, set outer TPID to 0xfffe:
DGS-1100-06/ME:5# config qinq ports all outer_tpid 0xfffe role uni
Command: config qinq ports all outer_tpid 0xfffe role uni
Warning: The outer TPID will be globally applied to all ports!
Success!
DGS-1100-06/ME:5#
To Next Page
Loading...
