2 INSTALLATION AND CONNECTIVITY
This chapter guides you through the hardware setup of the DEQX.
2.1 UNPACKING THE UNIT
Carefully remove the unit and the accessory kit from the shipping carton. Visually check
for shipping damage. Contact both the shipper and DEQX immediately if the unit or any
of the accessories bear any sign of damage from mishandling. All DEQX equipment is
carefully inspected before leaving our factory.
Keep the shipping carton and packing materials for future use or in the unlikely event
that the product needs servicing. If the product is shipped without the original
packaging, damage could occur and void the warranty.
Accessory kit contents
You should find the following in the accessory kit:
x One (1) AC mains cable
x One (1) USB cable
x One (1) microphone cable
x One (1) CD-ROM with the DEQX Calibration software and USB drivers
x One (1) measurement microphone with microphone holder
x One (1) remote control
x Two (2) AAA batteries
x One (1) printed User Manual (additional documentation is located on the CD-ROM)
Physical installation
The DEQX must be placed on a sturdy level surface, such as a shelf or in a suitable rack
or cabinet. Allow a minimum of 5 cm (2 inches) on both sides for ventilation.
During initial setup and calibration, it may be preferred to not install the unit within a
rack or cabinet, in order to allow easy access to the rear panel.
To Next Page
Loading...