Chapter 17. Project Explorer Reference
17.4 WORKING WITH MULTIPLE PROJECTS
The project explorer can open more than one project at a time.
Note: this feature is not intended as a general-purpose mechanism for sharing data
between projects. The primary purpose of this function is to enable the speaker
designer to create a project for distribution – that is, a project containing only what is
needed to upload a configuration to a DEQX in a different physical location, without all
of the other measurements and templates that may have been created during the
design process.
In general, it is best to use a single project for development work, even when using
multiple DEQX units (Chapter 14).
To open a second (or third etc.) project, drop down the File menu and choose “Insert
Project...” Select the project in the file browser and click OK. The project is added to the
project explorer:
Right-clicking on a project name provides two options:
Set as Active Project
The active project is the default selection on the first screen of each wizard. It is
also the project used for operations like Save.
Remove Project
Remove this project from the explorer.
If multiple projects are open, the various wizards provide an option on their first screen
to select the project to use for following steps. By default, the active project is selected,
but any other open project can be selected instead:
Note that it is not possible to have (for example) a calibration template in Project B
create a correction filter based on a speaker measurement that is in Project A. Each
wizard operates within the confines of the selected project.
To Next Page
Loading...