Chapter 6. Speaker Measurement
6.2 START THE SPEAKER MEASUREMENT WIZARD
If you do not already have a project open, open an existing project or create a new one.
Start the speaker measurement wizard by clicking on the
Measure Speakers button in the Wizard toolbar or by
selecting it from the Tools menu.
The wizard will take you through a series of screens. To proceed through them, select
the necessary options on each screen and click the Next button. If you realize you've
made a mistake or need to check what you've done, click the Back button to go back
through the screens already visited.
Screen 1. If you have more than one project open (page 149), this screen is used to
select the project in which the measurement will be stored. Otherwise, this is just an
informational screen.
Screen 2. Create a new measurement, or select an existing measurement to open. (The
following steps assume that you have selected “Create a new speaker measurement.”)
6.3 SET SPEAKER MEASUREMENT PARAMETERS
Screen 3. This screen sets a number of parameters that control the measurement. (See
next page for descriptions.)
To Next Page
Loading...