DEQX User Manual
Hardware
Selects the port that the computer uses to communicate with the DEQX. This
must always be set to USB for current generation software and products. (The
RS-232 mode is retained for specific legacy support reasons only.)
This setting has no effect on master/slave mode operation (Chapter 14).
Units
The measurement system that DEQX-Cal uses for recorded distances.
Name-Library File
The location and name of the file that DEQX-Cal uses to store names added by
the user (manufacturers, speaker models, measurement locations, and so on).
This must never be changed except on specific instruction from DEQX Support.
Default Project Location
The directory that DEQX-Cal uses by default for storing project files. This can be
changed if you prefer to store projects in a different location (for example, on a
network drive or external hard drive).
Enable separate digital/analog volume control
If checked, the DEQX remembers two volume control settings: one for the analog
inputs and one for the digital inputs. Changes to the master volume setting will
affect one or the other according to whether an analog or digital input is selected
at that time.
As an example usage of this feature: if the analog input is connected to the left
and right outputs of a home theater processor and the analog volume is set to
maximum, this effectively creates a “home theater bypass.”
Disable Front Panel Controls
If checked, the front panel controls for volume and profile selection do not
respond. (The Standby button still operates.) This is used when the DEQX is set
up as a slave unit (Chapter 14).
Disable Remote Control
If checked, the DEQX does not respond to remote control commands. This is used
when the DEQX is set up as a slave unit (Chapter 14).
Disable Front Panel LED Fadeout
Leave this option turned on.
Reload last project at startup
If checked, DEQX-Cal reloads the project that was in use when it was previously
closed. This is a convenience feature, and is checked by default.
To Next Page
Loading...