F
IGURES
– 36 –
Figure 32: Configuring Remote Port Mirroring (Intermediate) 137
Figure 33: Configuring Remote Port Mirroring (Destination) 138
Figure 34: Showing Port Statistics (Table) 141
Figure 35: Showing Port Statistics (Chart) 142
Figure 36: Performing Cable Tests 143
Figure 37: Configuring Static Trunks 145
Figure 38: Creating Static Trunks 146
Figure 39: Adding Static Trunks Members 146
Figure 40: Configuring Connection Parameters for a Static Trunk 147
Figure 41: Showing Information for Static Trunks 147
Figure 42: Configuring Dynamic Trunks 147
Figure 43: Configuring the LACP Aggregator Admin Key 149
Figure 44: Enabling LACP on a Port 150
Figure 45: Configuring LACP Parameters on a Port 151
Figure 46: Showing Members of a Dynamic Trunk 151
Figure 47: Configuring Connection Settings for Dynamic Trunks 152
Figure 48: Displaying Connection Parameters for Dynamic Trunks 152
Figure 49: Displaying LACP Port Counters 153
Figure 50: Displaying LACP Port Internal Information 155
Figure 51: Displaying LACP Port Remote Information 156
Figure 52: Enabling Power Savings 158
Figure 53: Enabling Traffic Segmentation 159
Figure 54: Configuring Members for Traffic Segmentation 161
Figure 55: Showing Traffic Segmentation Members 161
Figure 56: Configuring VLAN Trunking 162
Figure 57: Configuring VLAN Trunking 163
Figure 58: VLAN Compliant and VLAN Non-compliant Devices 166
Figure 59: Using GVRP 168
Figure 60: Creating Static VLANs 169
Figure 61: Modifying Settings for Static VLANs 170
Figure 62: Showing Static VLANs 170
Figure 63: Configuring Static Members by VLAN Index 173
Figure 64: Configuring Static VLAN Members by Interface 174
Figure 65: Configuring Static VLAN Members by Interface Range 175
Figure 66: Configuring Global Status of GVRP 177
Figure 67: Configuring GVRP for an Interface 177
To Next Page
Loading...
Need help?
General