iPECS-LIK
Feature Description & Operation Manual
: this will be useless if [SIP Phone Attributes (PGM 126) - Registration Timer
Usage] is ON
2. SIP Extension’s Local UDP/TCP/TLS Port number
3. Proxy Port : Server port number in sight of SIP Extension toward MFIM
4. Transport : Signaling mode
5. SIP Extension’s CODEC Priority
6. NTP Server and DST setting
7. Default volume of Speaker/Handset/Headset, maximum volume of Handset
8. Digit Map
If you can utilize SIP Phone’s programmable Dial Digit Map, you can make
immediate
sending out dials w/o press [SEND] or “#” key.
<Refer to below>
–
Digit Map (for Call Setup in SIP Phone)
: you can program Digit Map according to System Numbering Plan
Example) in case of “LIP8002/88xx” SIP Phone type
x.T|0|xx#|xxx#|1xxx|2xxx|3xxx|xxxx+#
Explanation)
“9” : dial “9” for attendant call, you can specify other single digit if you want it to
be sent immediately when press the digit without ending by “#”
‘1xxx’, ‘2xxx’, ‘3xxx’ : extension numbering, you can specify other 2 or 3 or 4 or
more digits starting with a specific prefix digit or digits.
‘xx#’, ‘xxx#’, ‘xxxx#’ : dial the other 2, 3 or 4 digits and press “#” to send
‘xxxx + #’ : dial the other more than 4 digits and press “#” to send.
–
Digit Map (for 2nd Dial Tone) : Play self dial tone by SIP Phone.
Example) in case of “LIP8002/88xx” SIP Phone type.
0 : //“0” is CO access code in the first CO group.
Operation
SIP Data / SIP Phone Provisioning(212)
1. Select one of CONFTYPE (Ericsson-LG Enterprise SIP Phone Type)
2. By default you do not need to input Private MAC address because you want to
make provisioning for all of CONFTYPE SIP Phones. If you want to make
provisioning for a specific individual SIP Phone then input Private Mac Address of
the SIP Phone.
3. Set the attributes you want to set for those type of SIP Phones on their registration
to system and press save button.
4. To view the saved information, press the view button.
NOTE
Abnormal Case : If you cannot see the saved provisioning data even though you saved
them, then you can try to solve the problem as below.
Cause of Problem : MFIM does not have enough working memory space, currently.
Resolution : Shut down “SIP Server”, save Provisioning, Start “SIP Server”
Step 1) Shut down SIP Server : connect COM1 and enter into maintenance mode, and
type maint> sipstack kill
// “SIP stack:kill(kill/start/refresh)” will be displayed on the screen
Step 2) Go to [SIP Data / SIP Phone Provisioning(212)] and implement saving
Provisioning
To Next Page
Loading...