RX1330 M3 Upgrade and Maintenance Manual 117
6.3.3.3 Installing the new hot-plug PSU
Ê Install the PSU as described in section "Installing a hot-plug PSU" on
page 110.
6.3.3.4 Concluding steps
Ê Connect the power cord to the new PSU and secure it with a cable tie as
described in section "Connecting the power cord" on page 64.
Ê Only when replacing a PSU in a non-redundant configuration: "Switching on
the server" on page 66
Ê "Performing a fan test" on page 101
6.3.4 Replacing the power distribution board
6.3.4.1 Preliminary steps
Ê "Locating the defective server" on page 50
Ê "Suspending BitLocker functionality" on page 71
Ê "Shutting down the server" on page 53
Ê "Disconnecting the power cord" on page 54
Ê "Getting access to the component" on page 55
Field Replaceable Unit
(FRU)
Hardware: 15 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver
To Next Page
Loading...
