Fujitsu PRIMERGY RX1330 M3

RX1330 M3 Upgrade and Maintenance Manual 125
Power supply unit (PSU)
Ê Remove the CMA stopper with the mounted crossbar (see figure 32).
Ê Hold the CMA stopper, the crossbar and the CMA including cables in the one
hand.
Ê Remove the FJBU and install the new FJBU carefully.
Ê Mount the complete assembly (CMA stopper, the crossbar and the CMA)
again into the rail.
6.4.3.1 Preliminary steps
Ê "Locating the defective server" on page 50
6.4.3.2 Removing the defective FJBU
Ê Remove the FJBU as described in "Removing an FJBU" on page 123.
6.4.3.3 Installing the new FJBU
Ê Install the FJBU as described in section "Installing an FJBU" on page 122.
6.4.3.4 Concluding steps
Ê No steps needed.