Fujitsu PRIMERGY RX1330 M3

RX1330 M3 Upgrade and Maintenance Manual 121
Power supply unit (PSU)
6.4 Fujitsu battery unit (FJBU)
6.4.1 Installing the FJBU
6.4.1.1 Preliminary steps
No steps needed.
6.4.1.2 Removing the dummy cover
Figure 39: Removing a dummy cover
Ê Press in on both release latches (1) and remove the dummy cover (2).
V CAUTION!
Keep the dummy cover for future use. If a FJBU is removed and not
immediately replaced by a new one, a dummy cover must be reinstalled
in the bay to comply with applicable EMC regulations and satisfy cooling
requirements.
Customer Replaceable Unit
(CRU)
Hardware: 5 minutes
Tools: tool-less