282 Upgrade and Maintenance Manual RX1330 M3
System board and components
14.3.3 Replacing the UFM
14.3.3.1 Preliminary steps
Ê "Locating the defective server" on page 50
Ê "Suspending BitLocker functionality" on page 71
Ê "Shutting down the server" on page 53
Ê "Disconnecting the power cord" on page 54
Ê "Getting access to the component" on page 55
Ê Remove the riser module 3 as described in section "Removing a riser
module" on page 66.
14.3.3.2 Removing the defective UFM
Ê Remove the UFM as described in section "Removing the UFM" on
page 280.
Ê The UFM spacer remains on the system board.
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Software: 5 minutes
Tools: – Phillips PH1 / (+) No. 1 screw driver
– combination pliers and flat nose pliers
To Next Page
Loading...
