202 Upgrade and Maintenance Manual RX1330 M3
Expansion cards and backup units
9.4.3.2 Removing an expansion card
Ê Remove the expansion card as described in section "Removing the
expansion card" on page 199.
Ê If the slot bracket on the defective expansion card is to be reused, remove it
from the expansion card as described in section "Removing a slot bracket"
on page 190.
9.4.3.3 Installing an expansion card
Ê If applicable, install the slot bracket as described in section "Installing a slot
bracket" on page 188.
Ê Install the expansion card as described in section "Installing the expansion
card" on page 198.
9.4.3.4 Connecting cables to the expansion card
Ê If applicable, connect internal cables to the expansion card.
I For the cable plan see section "Cabling plans" on page 312.
9.4.3.5 Concluding steps
Ê Install the corresponding riser module as described in section "Installing a
riser module" on page 68.
Ê "Reassembling" on page 60
Ê If applicable, connect external cables to the expansion card.
Ê "Connecting the power cord" on page 64
Ê "Switching on the server" on page 66
Ê "Enabling replaced components in the system BIOS" on page 90
Ê Inform the customer about changed WWN and MAC addresses, see
"Looking up changed MAC / WWN addresses" on page 97.
Ê "Updating the NIC configuration file in a Linux and VMware environment" on
page 94
Ê "Updating expansion card firmware" on page 82
Ê "Resuming BitLocker functionality" on page 95
To Next Page
Loading...
