RX1330 M3 Upgrade and Maintenance Manual 201
Expansion cards and backup units
9.4.3 Replacing an expansion card
Note on network settings recovery
I When replacing network controllers or the system board, network
configuration settings in the operating system will be lost and replaced
by default values. This applies to all static IP address and LAN teaming
configurations.
Ensure to note down your current network settings before replacing a
network controller or the system board.
9.4.3.1 Preliminary steps
Ê "Suspending BitLocker functionality" on page 71
Ê If applicable, note "Configuring LAN teaming" on page 99.
Ê "Locating the defective server" on page 50
Ê If applicable, ensure to note down your current network settings in the
operating system.
Ê "Shutting down the server" on page 53
Ê "Disconnecting the power cord" on page 54
Ê If applicable, disconnect external cables to the expansion card.
Ê "Getting access to the component" on page 55
Ê "Locating the defective component" on page 51
Ê Remove the corresponding riser module as described in section "Removing
a riser module" on page 66.
Upgrade and Repair Unit
(URU)
Hardware: 10 minutes
Software: 5 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver (only for replace the slot bracket)
To Next Page
Loading...
