Fujitsu PRIMERGY RX1330 M3

118 Upgrade and Maintenance Manual RX1330 M3
Power supply unit (PSU)
6.3.4.2 Removing the defective power distribution board
Ê Remove all PSUs as described in section "Removing a hot-plug PSU" on
page 114.
Figure 36: Removing the power distribution board
Ê Disconnect the two power cables from the power distribution board (see
orange arrows).
Ê Remove the screw (see circle).
Ê Lift the power distribution board out of the centering ring on the standoff (1)
and move it in direction of the system board (2).
Ê Take the power distribution board out upward (3).