66 Upgrade and Maintenance Manual RX1330 M3
Basic hardware procedures
4.7 Switching on the server
V CAUTION!
● Before switching on the server, make sure the top cover is closed. In
order to comply with applicable EMC regulations (regulations on
electromagnetic compatibility) and satisfy cooling requirements, the
server must not run while the top cover is removed.
● For further safety information, please refer to chapter "Important
information" on page 35.
Ê Press the On/Off button to start up the server.
Ê Ensure that the power-on indicator above the On/Off button is lit green.
Ê Perform the required procedures described in the concluding steps of each
upgrade or maintenance task.
4.8 Handling riser modules
4.8.1 Removing a riser module
Figure 12: Removing the riser module 1
To Next Page
Loading...
