308 Upgrade and Maintenance Manual RX1330 M3
System board and components
14.7.1.4 Concluding steps
Ê "Installing the iRMC microSD card" on page 298 (if applicable)
Ê "Installing the SATA DOM" on page 294 (if applicable)
Ê "Installing the TPM" on page 285 (if applicable)
Ê "Installing the UFM" on page 276 (if applicable)
Ê Install the memory modules, see section "Installing a memory module" on
page 226.
I Make sure that you reinstall each memory module in the slot it was
located before the replacement.
Ê Install the heat sink, see section "Installing the heat sink" on page 240.
Ê Install all expansion cards, see section "Expansion cards and riser cards" on
page 197.
I Make sure that you reinstall each card in the slots it was located
before the replacement.
Ê "Reassembling" on page 60
Ê "Connecting the power cord" on page 64
Ê Connect all external cables.
Ê "Switching on the server" on page 66
I If the Global Error LED is flashing with the error message "CPU has
been changed" on the display after the system is powered on, please
follow the steps below.
Ê Restart the system and wait until the screen output appears.
Ê Press [F2].
Ê If a password is assigned, enter this password and confirm with
[Enter].
The BIOS setup main menu will be displayed on the screen.
Ê Select "Save Changes and Exit" or "Save Changes and Reset" on
the Save & Exit menu.
Ê Confirm that the Global Error LED is off.
This is only information regarding to the change of the CPU
configuration. There is no technical problem.
To Next Page
Loading...
