RX1330 M3 Upgrade and Maintenance Manual 169
Hard disk drive (HDD) / solid state drive (SSD)
7.3.2 Installing 3.5-inch HDD modules
7.3.2.1 Preliminary steps
Ê Locate the correct drive bay as described in section "3.5-inch HDD
configurations" on page 168.
7.3.2.2 Removing a 3.5-inch HDD dummy module
Figure 89: Removing a 3.5-inch dummy module
Ê Press both tabs together (1) and pull the dummy module out of its bay (2).
V CAUTION!
Save the dummy module for future use.
Always replace dummy modules into unused HDD bays to comply with
applicable EMC regulations and satisfy cooling requirements.
Customer Replaceable Unit
(CRU)
Hardware: 5 minutes
Tools: tool-less
To Next Page
Loading...
