RX200 S8
Upgrade and Maintenance Manual 101
Power supply
6.4.3 Installing the new power supply unit
Ê Install the power supply unit as described in section "Installing the power
supply unit" on page 94.
6.4.4 Concluding steps
Ê "Connecting the server to the mains" on page 57
Ê Only when replacing a power supply unit in a non-redundant configuration:
"Switching on the server" on page 58
Ê "Performing a fan test after replacing a defective fan" on page 89
6.5 Replacing the power distribution board
6.5.1 Preliminary steps
Ê "Locating the defective server" on page 43
Ê "Disabling BitLocker functionality" on page 63
Ê "Shutting down the server" on page 46
Ê "Disconnecting the server from the mains" on page 47
Ê "Getting access to the component" on page 47
Ê "Removing the riser module 3" on page 60
Field Replaceable Unit
(FRU)
Hardware: 15 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver
To Next Page
Loading...
