RX200 S8
Upgrade and Maintenance Manual 311
System board and components
15.6.4 Concluding steps
Ê "Installing the onboard SAS enabling key" on page 299 (if applicable)
Ê "Installing the TPM" on page 289 (if applicable)
Ê "Installing the UFM" on page 282 (if applicable)
Ê Install all fan modules, see section "Installing the new fan module" on
page 134.
I Make sure that you reinstall each fan module in the bay it was located
before the replacement.
Ê Install all memory modules, see section "Installing a memory module" on
page 205.
I Make sure that you reinstall each memory module in the slot it was
located before the replacement.
Ê Install all heat sinks, see section "Installing the heat sink" on page 231.
Ê "Installing the new front LAN card" on page 262 (if applicable)
Ê Install all expansion cards see section "Expansion cards and riser cards" on
page 152.
I Make sure that you reinstall each card in the slots it was located
before the replacement.
Ê "Installing the air duct" on page 62
Ê "Reassembling" on page 52
Ê "Connecting the server to the mains" on page 57
Ê Connect all external cables.
Ê "Updating or recovering the system board BIOS and iRMC" on page 70
Ê If applicable, activate TPM functionality in the system BIOS under Security >
TPM (Security Chip) Setting > Security Chip. For more information, refer to the
corresponding BIOS Setup Utility reference manual.
Ê "Verifying system information backup / restore" on page 73
Ê "Verifying the system time settings" on page 80
Ê "Looking up changed MAC / WWN addresses" on page 85
Ê "Updating the NIC configuration file in a Linux environment" on page 82
To Next Page
Loading...
