RX200 S8
Upgrade and Maintenance Manual 261
Front panel and front VGA/LAN module
13.4.3 Installing the new front VGA and/or front LAN cable
Ê Install the front LAN and/or front VGA connector as described in section
"Installing the front connectors" on page 247.
Ê Install the front VGA/LAN module as described in section "Removing the
front VGA/LAN module" on page 246.
Ê Connect the front VGA cable as described in section "Connecting the front
VGA cable" on page 251.
Ê Connect the front LAN cable as described in section "Connecting the front
LAN cable" on page 251.
13.4.4 Concluding steps
Ê "Installing the riser module 3" on page 61
Ê "Reassembling" on page 52
Ê "Connecting the server to the mains" on page 57
Ê "Switching on the server" on page 58
Ê "Enabling BitLocker functionality" on page 83
13.5 Replacing the front LAN card
13.5.1 Preliminary steps
Ê "Shutting down the server" on page 46
Ê "Disconnecting the server from the mains" on page 47
Ê "Getting access to the component" on page 47
Ê "Removing the riser module 3" on page 60
Upgrade and Repair Unit
(URU)
Hardware: 10 minutes
Tools: tool-less
To Next Page
Loading...
