Fujitsu PRIMERGY RX200 S8 - Replacing a Memory Module

208 Upgrade and Maintenance Manual RX200 S8
Main memory
10.3.3 Concluding steps
Ê "Installing the air duct" on page 62
Ê "Reassembling" on page 52
Ê "Connecting the server to the mains" on page 57
Ê "Switching on the server" on page 58
Ê "Enabling BitLocker functionality" on page 83
10.4 Replacing a memory module
10.4.1 Preliminary steps
Ê "Locating the defective server" on page 43
Ê "Disabling SVOM boot watchdog functionality" on page 64
Ê "Disabling BitLocker functionality" on page 63
Ê "Shutting down the server" on page 46
Ê "Disconnecting the server from the mains" on page 47
Ê "Getting access to the component" on page 47
Ê "Removing the air duct" on page 62
Ê "Locating the defective component" on page 45
10.4.2 Removing the defective memory module
Ê Remove the memory module as described in section "Removing a memory
module" on page 207.
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Tools: tool-less