232 Upgrade and Maintenance Manual
RX200 S8
Processors
11.3.7 Concluding steps
Ê "Installing the air duct" on page 62
Ê "Reassembling" on page 52
Ê "Connecting the server to the mains" on page 57
Ê "Updating or recovering the system board BIOS and iRMC" on page 70
Ê "Enabling SVOM boot watchdog functionality" on page 78
Ê "Switching on the server" on page 58
Ê "Enabling BitLocker functionality" on page 83
11.4 Replacing a heat sink
11.4.1 Preliminary steps
Ê "Locating the defective server" on page 43
Ê "Shutting down the server" on page 46
Ê "Disconnecting the server from the mains" on page 47
Ê "Getting access to the component" on page 47
Ê "Removing the air duct" on page 62
11.4.2 Removing the defective heat sink
Ê Remove the heat sink as described in section "Removing the heat sink" on
page 223.
Ê Remove the residual thermal paste from the processor surface.
Ê Clean the processor surface using a lint-free cloth.
Field Replaceable Unit
(FRU)
Hardware: 15 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver
To Next Page
Loading...
