RX200 S8
Upgrade and Maintenance Manual 309
System board and components
I Returned system boards without this cover probably have to be
scrapped.
15.6.3 Installing the new system board
Ê Install the processor as described in section "Installing the new processor"
on page 227).
Ê Check the settings on the new system board (see section "Onboard
settings" on page 334).
Ê Insert the system board by holding it at a slight angle. Slide the connectors
into the connector panel (see figure 239 on page 308).
Ê Lower the system board carefully into the chassis.
Ê Adjust the system board. If necessary adjust the position of the system
board with a gentle twisting motion.
I When the system board is in the right position, the centre rings engage
with the holes indicated.
Ê Fasten the system board with the nine screws (see figure 238 on page 307).
Ê Install the distance holder (see figure 237 on page 307).
To Next Page
Loading...
