120 Upgrade and Maintenance Manual
RX200 S8
Hard disk drives / solid state drives
Ê Insert all HDD/SSD modules, see section "Installing the 2.5-inch HDD/SSD
module" on page 112.
I Make sure that you reinstall the HDD/SSD module in the bay it was
located before the 4xHDD backplane replacement.
7.5.4 Concluding steps
Ê "Reassembling" on page 52
Ê "Connecting the server to the mains" on page 57
Ê "Switching on the server" on page 58
7.6 Replacing the 8xHDD backplane
7.6.1 Preliminary steps
Ê "Locating the defective server" on page 43
Ê "Shutting down the server" on page 46
Ê "Disconnecting the server from the mains" on page 47
Ê "Getting access to the component" on page 47
Ê "Removing the air duct" on page 62
Field Replaceable Unit
(FRU)
Hardware: 10 minutes
Tools: tool-less
To Next Page
Loading...
