Fujitsu PRIMERGY RX200 S8 - Removing the BBU from the Holder; Disconnecting the BBU Cable from the BBU

186 Upgrade and Maintenance Manual RX200 S8
Expansion cards and backup units
9.5.4.3 Removing the BBU from the holder
Figure 126: Removing the BBU from the holder
Ê Press out on the retaining bracket on the holder (1), lift the battery at the
bottom side and remove the BBU at a slight angle out of the holder (2).
9.5.4.4 Disconnecting the BBU cable from the BBU
Figure 127: Disconnecting the BBU cable from the BBU
Ê Disconnect the BBU cable from the BBU.
V CAUTION!
Do not disconnect the cable using excessive force, the connector is
weak.
/
0