RX200 S8
Upgrade and Maintenance Manual 115
Hard disk drives / solid state drives
7.3.3 Installing the 2.5-inch dummy module
Figure 45: Installing the 2.5-inch dummy module
Ê Push the dummy module into the empty bay until it engages.
7.3.4 Concluding steps
No steps needed.
7.4 Replacing a 2.5-inch HDD/SSD module
V CAUTION!
●
Only remove an HDD/SSD module during operation if the drive is not
currently being accessed. Observe the indicators for the
corresponding HDD/SSD modules, see "RX200 S8 Server -
Operating Manual".
●
Under no circumstances should you remove an HDD/SSD module
while the system is in operation if you are not sure that the drive is
operated by a RAID controller and belongs to a disk array that is
operating in RAID level 1, 1E, 10, 5, 50, 6 or 60.
Customer Replaceable Unit
(CRU)
Hardware: 5 minutes
Tools: tool-less
To Next Page
Loading...
