Fujitsu PRIMERGY RX200 S8 - Installing the BBU in the Holder

RX200 S8 Upgrade and Maintenance Manual 173
Expansion cards and backup units
Figure 107: Connecting the BBU cable
Ê Connect the BBU cable to the BBU.
V CAUTION!
Make sure that the connector side with the three dots is on the top (see
close-up). Otherwise you risk short-circuits.
9.5.2.3 Installing the BBU in the holder
Figure 108: Installing the BBU in the holder
Ê At a slight angle, fit the BBU under the right retaining bracket on the holder
(1).
Ê Fold down the BBU until it locks in place (2).