RX200 S8
Upgrade and Maintenance Manual 117
Hard disk drives / solid state drives
7.5 Replacing the 4xHDD backplane
7.5.1 Preliminary steps
Ê "Locating the defective server" on page 43
Ê "Shutting down the server" on page 46
Ê "Disconnecting the server from the mains" on page 47
Ê "Getting access to the component" on page 47
7.5.2 Removing the defective 4xHDD backplane
Ê Release all HDD/SSD modules and pull them out a few centimeters, see
section "Removing the 2.5-inch HDD/SSD module" on page 114
I The HDD/SSD modules need not to be completely removed. But if
you want to completely remove them nevertheless, check if all
HDD/SSD modules are uniquely identified so that you can reinsert
them into their original bays.
Field Replaceable Unit
(FRU)
Hardware: 10 minutes
Tools: tool-less
To Next Page
Loading...
