RX200 S8
Upgrade and Maintenance Manual 285
System board and components
15.3.2.2 Removing the UFM
Figure 218: Removing the UFM
Ê Remove the nylon screw of the UFM (1).
Ê Disconnect and remove the UFM (2).
Figure 219: Remaining UFM spacer
The UFM spacer remains on the system board.
V CAUTION!
UFM contains customer information (e.g. IP address, License etc.). After
replacing the UFM, you must pass the defective UFM to the customer,
and ask for disposal. If the disposal of the defective UFM is requested by
the customer, you break it according to the following procedure, and
dispose it.
To Next Page
Loading...
