RX200 S8
Upgrade and Maintenance Manual 165
Expansion cards and backup units
9.4.5.3 Installing the new expansion card
Ê Install the expansion card as described in section "Installing the expansion
card - slot 1-3" on page 154 or "Installing the expansion card - slot 4" on
page 157.
9.4.5.4 Concluding steps
Ê Install the corresponding riser module as described in section "Handling
riser modules" on page 58.
Ê "Reassembling" on page 52
Ê "Connecting the server to the mains" on page 57
Ê "Enabling replaced components in the system BIOS" on page 79
Ê "Updating RAID controller firmware" on page 73
Ê "Enabling SVOM boot watchdog functionality" on page 78
Ê "Switching on the server" on page 58
Ê "Enabling BitLocker functionality" on page 83
Ê After replacing a network controller in a server running Linux OS, "Updating
the NIC configuration file in a Linux environment" on page 82.
Ê If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card or onboard).
I Configuration of network settings should be performed by the
customer. For further information, please refer to section "Note on
network settings recovery" on page 164
Ê If applicable, restore LAN teaming configurations, see "After replacing /
upgrading LAN controllers" on page 88.
Ê Inform the customer about changed WWN and MAC addresses, see
"Looking up changed MAC / WWN addresses" on page 85.
To Next Page
Loading...
