Fujitsu PRIMERGY RX200 S8 - Sliding the Server into the Rack

56 Upgrade and Maintenance Manual RX200 S8
Basic hardware procedures
4.5.4 Sliding the server into the rack
Figure 11: Sliding the server into the rack
Ê Check if the height of the fan cover and the chassis top are on the same level
If the fan cover is higher, push it down again until the level is equal.
Ê Release the locking mechanism of both rails (1).
Ê Push the server as far as it will go into the rack (2) until the quick-release
levers engage (3).
V CAUTION!
Be careful with your fingers. You can pinch them when the quick-
release levers change to the release position.
Ê Reconnect all cables except the power cord to the server rear.
/
0
1
0
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1