RX200 S8
Upgrade and Maintenance Manual 125
Hard disk drives / solid state drives
7.7 Converting to configuration up to eight
HDD/SSD modules
7.7.1 Preliminary steps
Ê "Locating the defective server" on page 43
Ê "Shutting down the server" on page 46
Ê "Disconnecting the server from the mains" on page 47
Ê "Getting access to the component" on page 47
Ê "Removing the air duct" on page 62
7.7.2 Removing the 4xHDD backplane and the ODD cage
Ê Remove the 4xHDD backplane as described in section "Removing the
defective 4xHDD backplane" on page 117.
Ê If applicable, remove the ODD from its bay.
Upgrade and Repair Unit
(URU)
Hardware: 15 minutes
Tools: Replacing the cage: Phillips PH2 / (+) No. 2 screw driver
To Next Page
Loading...
Need help?
General