RX200 S8
Upgrade and Maintenance Manual 193
Expansion cards and backup units
9.5.7.3 Installing the new FBU
Ê Install the FBU in the holder as described in section "Installing the FBU in
the holder" on page 179.
Ê Connect the FBU cable to the FBU as described in section "Connecting the
FBU cable to the FBU" on page 180.
Ê Install the FBU with the holder as described in section "Installing the FBU
with the holder" on page 180.
9.5.7.4 Concluding steps
Ê "Installing the riser module 3" on page 61
Ê "Reassembling" on page 52
Ê "Connecting the server to the mains" on page 57
Ê "Updating RAID controller firmware" on page 73
Ê "Enabling SVOM boot watchdog functionality" on page 78
Ê "Switching on the server" on page 58
To Next Page
Loading...
