170 Upgrade and Maintenance Manual
RX200 S8
Expansion cards and backup units
9.4.7 Replacing TFM
9.4.7.1 Preliminary steps
Ê "Locating the defective server" on page 43
Ê "Shutting down the server" on page 46
Ê "Disconnecting the server from the mains" on page 47
Ê "Getting access to the component" on page 47
Ê "Locating the defective component" on page 45
Ê "Removing the riser module 3" on page 60
9.4.7.2 Removing the defective TFM
Ê Remove the depending expansion card as described in section "Removing
an expansion card - slot 4" on page 162.
Figure 105: Disconnecting the FBU cable from the TFM
Ê Disconnect the FBU cable from the TFM.
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Tools: Phillips PH1 / (+) No. 1 screw driver
To Next Page
Loading...
