260 Upgrade and Maintenance Manual
RX200 S8
Front panel and front VGA/LAN module
13.4 Replacing the front VGA and/or front LAN
cable
13.4.1 Preliminary steps
Ê "Locating the defective server" on page 43
Ê "Disabling BitLocker functionality" on page 63
Ê "Shutting down the server" on page 46
Ê "Disconnecting the server from the mains" on page 47
Ê "Getting access to the component" on page 47
Ê "Removing the riser module 3" on page 60
13.4.2 Removing the defective front VGA and/or front
LAN cable
Ê Disconnect the front LAN cable as described in section "Disconnecting the
front LAN cable" on page 254.
Ê Disconnect the front VGA cable as described in section "Disconnecting the
front VGA cable" on page 255.
Ê Remove the front VGA/LAN module as described in section "Removing the
front VGA/LAN module" on page 246.
Ê Remove the front LAN and/or front VGA connector as described in section
"Removing the front connectors" on page 256.
Upgrade and Repair Unit
(URU)
Hardware: 10 minutes
Tools: tool-less
To Next Page
Loading...
Need help?
General