Fujitsu PRIMERGY RX200 S8 - Preliminary Steps; Removing the Defective 2.5-Inch HDD;SSD Module; Installing the New 2.5-Inch HDD;SSD Module; Concluding Steps

116 Upgrade and Maintenance Manual RX200 S8
Hard disk drives / solid state drives
An HDD/SSD module can only be replaced during operation in
conjunction with a corresponding RAID configuration.
● All HDD/SSD modules (drives) must be uniquely identified so that
they can be reinstalled in their original bays later. If this is not done,
existing data can be lost.
V Only applicable for removing non-defective HDD/SSD modules:
Ê Set the drive to "Offline" via the software (RAID controller
configuration software), before removing an HDD/SSD module that is
not defective.
7.4.1 Preliminary steps
Ê "Locating the defective server" on page 43
Ê "Locating the defective component" on page 45
7.4.2 Removing the defective 2.5-inch HDD/SSD module
Ê Remove the HDD/SSD module as described in section "Removing the 2.5-
inch HDD/SSD module" on page 114.
7.4.3 Installing the new 2.5-inch HDD/SSD module
Ê Install the HDD/SSD module as described in section "Installing the 2.5-inch
HDD/SSD module" on page 112.
7.4.4 Concluding steps
Ê "Performing a RAID array rebuild" on page 84