Fujitsu PRIMERGY RX200 S8 - Removing the Defective Front Panel Board

264 Upgrade and Maintenance Manual RX200 S8
Front panel and front VGA/LAN module
13.6.2 Removing the defective front panel board
Figure 194: Disconnecting the front panel cable
Ê Disconnect the front panel cable from the system board connector "Front
Panel".
Ê Take the front panel cable out of the guiding (A).
Ê If applicable, disconnect the front LAN cable as described in section
"Disconnecting the front LAN cable" on page 254.
Ê If applicable, disconnect the front VGA cable as described in section
"Disconnecting the front VGA cable" on page 255.
A