Fujitsu PRIMERGY RX200 S8 - Installing the New UFM; Concluding Steps

288 Upgrade and Maintenance Manual RX200 S8
System board and components
15.3.3.3 Installing the new UFM
Figure 222: Removing the UFM spacer
Ê Remove the nylon screw from the UFM (1).
Ê Remove the UFM spacer (2).
Figure 223: Installing the UFM
Ê Connect the UFM to the system board and the remaining UFM spacer (1).
Ê Fasten the UFM to the UFM spacer with the nylon screw (2).
15.3.3.4 Concluding steps
Ê "Installing the riser module 3" on page 61
Ê "Reassembling" on page 52
/
0