Fujitsu PRIMERGY RX200 S8 - Removing the Onboard SAS Enabling Key; Preliminary Steps; Concluding Steps

RX200 S8 Upgrade and Maintenance Manual 301
System board and components
15.5.2 Removing the onboard SAS enabling key
15.5.2.1 Preliminary steps
Ê "Shutting down the server" on page 46
Ê "Disconnecting the server from the mains" on page 47
Ê "Getting access to the component" on page 47
Ê "Removing the air duct" on page 62
15.5.2.2 Removing the onboard SAS enabling key
Figure 235: Removing the onboard SAS enabling key
Ê Firmly pull up on the release lash until the onboard SAS enabling key pops
out of its connector.
15.5.2.3 Concluding steps
Ê "Installing the air duct" on page 62
Ê "Reassembling" on page 52
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Tools: tool-less