128 Upgrade and Maintenance Manual
RX200 S8
Hard disk drives / solid state drives
Figure 59: Fastening the 2x HDD cage
Ê Fasten the 2xHDD cage with the screw (see circle).
Ê Remove the fan cage as described in section "Removing the defective
8xHDD backplane" on page 121.
Ê If applicable, install a 2-channel RAID controller as described in section
"Installing an expansion card - slot 4" on page 157.
Ê Install the 8xHDD backplane as described in section "Installing the new
8xHDD backplane" on page 123.
Figure 60: Removing the HDD locks
Ê Pull out the two HDD locks frontward.
Ê Remove the two dummy modules as described in section "Removing the
2.5-inch dummy module" on page 111.
To Next Page
Loading...
