RX200 S8
Upgrade and Maintenance Manual 175
Expansion cards and backup units
The shoulder screw caps on the chassis floor will lock in the narrow ends of
the keyhole slots on the holder.
Ê Ensure that the locking handle on the holder properly snaps in place (see
circle).
Figure 111: Connecting the BBU cable to the RAID controller
Ê Install a RAID controller as described in section "Installing the expansion
card - slot 4" on page 157.
Ê Connect the BBU cable to the RAID controller (see circle).
V CAUTION!
●
Make sure that the connector side with the three dots is on the top.
Otherwise you risk short-circuits.
●
Do not connect the cable using excessive force, the connector is
weak.
To Next Page
Loading...
Need help?
General