Figure 54: Connecting SAS cables to the expander board
Figure 55: Connecting SAS cables to the system board
Ê Connect the two SAS cables to the SAS expander board:
– (1) from SAS controller connector MLC1 to SAS expander board
– (2) from SAS controller connector MLC2 to SAS expander board
7.3.3.6 Concluding steps
Ê "Installing the fan box" on page 156
Ê "Reassembling" on page 61
Ê Insert all HDD/SSD modules, see section "Installing 3.5-inch HDD modules"
on page 115
I Make sure that you reinstall the HDD/SSD module in the bay it was
located before the HDD backplane replacement.
Ê "Connecting the server to the power source" on page 66
Ê "Switching on the server" on page 67
햲
햳
To Next Page
Loading...
