Fujitsu PRIMERGY RX2540 M1 - Removing Expansion Cards; Preliminary Steps; Removing an Expansion Card

RX2540 M1 Upgrade and Maintenance Manual 181
Expansion cards and backup units
Ê If applicable, "Updating RAID controller firmware" on page 81.
Ê If applicable, "Enabling Option ROM scan" on page 82.
Ê "Enabling SVOM boot watchdog functionality" on page 86
Ê "Enabling BitLocker functionality" on page 92
9.4.2 Removing expansion cards
9.4.2.1 Preliminary steps
Ê "Locating the defective server" on page 51
Ê "Disabling or suspending BitLocker functionality" on page 69
Ê "Disabling SVOM boot watchdog functionality" on page 70
Ê "Shutting down the server" on page 53
Ê Remove all external cables from the expansion card to be removed.
Ê "Disconnecting power cords" on page 54
Ê "Getting access to the component" on page 55
9.4.2.2 Removing an expansion card
Ê If applicable, disconnect internal cables from the expansion card.
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver